DeDietrich DTI1041X Manual de instrucciones Pagina 12

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 16
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 11
12
EN
4 / SPECIAL MESSAGES, DIFFICULTIES
The hob does not operate and
the indicator lights on the con-
trol panel do not light up.
The hob is not working and
another message is displayed.
The hob does not function, the
information is displayed.
The machine is not connected to
the power source. The power
source or connection is defective.
The electronic board is func-
tioning poorly.
The hob is locked
Inspect the electrical cir-
cuit breaker and fuses.
Call the After-Sales
Service Department.
See chapter on using the
child safety system
•On switching on
YOU OBSERVE THAT: POSSIBLE CAUSES:
WHAT SHOULD YOU DO?
POSSIBLE CAUSES:
WHAT SHOULD YOU DO?
A special lamp appears.
Your installation blows a fuse.
Only one side works.
The hob produces an odour dur-
ing the first cooking sessions.
Working normally.
The electrical connection of
your hob is incorrect.
New appliance.
Nothing, the light disappears
after 30 seconds.
Check that it is set up
properly.
See the “Electrical
Connection” section.
Nothing. The smell will dis-
appear after several uses.
•On first use
•While in use
YOU OBSERVE THAT: POSSIBLE CAUSES: WHAT SHOULD YOU DO?
The hob has stopped operating and is
beeping approximately every 10 sec-
onds and a or F7 is displayed.
There was an overflow or an
object is in contact with the
control panel.
Clean the hob or remove the
object, then begin cooking
again.
A series of small or F7 is dis-
played.
The electronic boards heated
up.
See “Inserting” section.
Af
ter turning on a heating zone, the
indicat
or lights on the control panel
continue to flash.
The cookw
are used is not suit-
able f
or induction or is less
than 12 cm in diameter (10 cm
on a 16 cm area).
See section on cookw
are for
induction.
The saucepans make noise during
cooking.
Your hob makes a clicking sound dur-
ing cooking.
This is normal with some
types of cookware. This is
caused by the transfer of
energy from the hob to the
cookware.
Nothing. There is no risk, nei-
ther to your hob nor to your
cookware.
The fan continues to function a few min-
utes after your hob is turned off.
Cooling of the electronic com-
ponents.
W
or
king normally.
Nothing.
After turning on a heating zone, t
he
indicator lights on the contr
ol panel
remain steady but the cookware is not
heated.
The cookw
ar
e used is no
t
suit
able f
or use wit
h induc
-
tion.
See section on cookw
ar
e f
or
induction.
Vista de pagina 11
1 2 ... 7 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios