37
1 / INSTALLING YOUR APPLIANCE
••
CHOICE OF LOCATION
Your appliance shoud be flush mounted in the
surface of a support cabinet that is a minimum of 3
cm thick, made of a material that resists heat or that
is covered with such a material.
So as not to inhibit the movement of cooking
utensils, there should not be to any obstacle within
30 cm of the hob to the right or left or back.
If a horizontal divider wall is positioned under the
hob, it should be placed between 10 cm and 15 cm
away from the top of the work surface. Never store
aerosol cans or pressurised containers in any
compartment that may exist under the hob (see
chapter
“
Safety instructions
”
).
BEFORE INSTALLATION
Before installation of your appliance and to ensure
leaktightness between the drawer unit and the work
surface, make sure that you glue the seal provided
in the plastic bag
(Fig. 02)
.
——
Remove the pan supports, the burner covers and
burner heads; noting their positions.
——
Turn the hob over and carefully place it on top of
the opening in the cabinet so as not to damage the
knobs and spark plugs.
——
Glue the foam seal, supplied with the appliance,
ttoo tthhee oouuttssiiddee eeddggee ooff tthhee ffrraammee
. This seal ensures
leaktightness between the glass and the work
surface.
(
Fig. 02:
model with touch-sensitive controls).
——
Place your hob in the opening of the support unit,
carefully centering it in the cut-out.
——
Reposition the pan supports, burner covers and
burner heads.
——
Connect the hob’s power cable to your kitchen’s
electricity supply (see section “
EElleeccttrriicciittyy
ccoonnnneeccttiioonn
”).
——
Connect your appliance to the gas supply (see
section “
GGaass ccoonnnneeccttiioonn
”).
••
Comentarios a estos manuales