43
CHANGING FROM BUTANE/PROPANE
TO NATURAL GAS
During this operation, BEFORE ANY CONNECTION IS
MADE
, you must complete the following steps:
— Turn the gas changing switch TO THE RIGHT
(Fig. 01).
— Adapt the gas connection
— Change the injectors
—Adjust the hob connections
•
TTuurrnn tthhee ggaass cchhaannggiinngg sswwiittcchh::
your appliance is
supplied by butane/propane You must flip the gas
changing switch on the right front of your hob to the
network gas (natural gas) position (Fig. 01), or to the
right.
•
AAddaapptt tthhee ggaass ccoonnnneeccttiioonn::
refer to the
""GGaass
CCoonnnneeccttiioonn""
section
..
•
CChhaannggee tthhee iinnjjeeccttoorrss,,
proceeding as follows:
— Remove the pan supports, heads and covers from
all burners.
— Using the wrench provided, unscrew the injectors
located under each crucible and remove them (Fig
02).
— Replace with the corresponding gas injectors, in
compliance with the positioning of the injectors and
the table of gas properties at the end of this section:
— First screw them in manually until the injector
locks into place.
— Apply the wrench to the injector as far as it will go.
— Draw a line on the burner plate using a pencil at
the place indicated (Fig 03).
— Turn the wrench clockwise until the line appears
on the other side (Fig. 04).
Warning
Exceeding this limit may damage the
product.
-
Replace the burner heads, burner covers and pan
supports on the hob.
YYOOUURR HHOOBB IISS NNOOWW RREEAADDYY TTOO BBEE UUSSEEDD WWIITTHH
NNEETTWWOORRKK ((NNAATTUURRAALL)) GGAASS..
••
Tip
Each time you change the gas supply,
tick the box corresponding to the new gas
level on the label found in the plastic bag.
Refer to the corresponding "Gas
Connection" section.
Fig. 03
Fig. 04
Line
Line
Wrench
Wrench
Fig. 02
Wrench
Injector
Crucible
Fig. 01
Switch
1/ INSTALLING YOUR APPLIANCE
Natural
gas
Butane/Propane
Comentarios a estos manuales